Roland VR-50HD MK II - Rear Panel Connectors

6
Basic Operations
Setting the Output Format
Here’s how to specify the output format as appropriate for the device
that’s connected.
1. Press the [MENU] button to display the MENU screen.
2. Touch Video < Output >.
3. Touch < Format >.
4. Touch a button to select the output format.
The output format switches.
5. Press the [MENU] button to close the menu.
MEMO
5
If the output format is set to “1024x768”–“1920x1080,” video is
not output from the SDI OUT (PGM, AUX) connectors.
5
The output format of the MULTI-VIEW connector is xed at
1080/60p.
5
The video output format of the USB STREAM port can be set by
the [MENU] button
0
System <USB Stream>
0
<Resolution>.
Switching the Video
Assigning video sources
Here’s how to assign the video sources being input from the video
input connectors to the VIDEO INPUT SELECT [1]–[4] buttons.
1. Press the [INPUT ASSIGN] button.
The [INPUT ASSIGN] button is lit, and the video source select
screen appears.
2. Touch a button to select the video source (connector
name) that you want to input to Video Input 1–4.
Video Input 2Video Input 1
Video Input 3 Video Input 4
3. Press the [INPUT ASSIGN] button to close the screen.
Switching the Video
1. Press one of the [CUT], [MIX], or [WIPE] button to select
the transition eect.
2. If you selected mix or wipe in step 1, turn the [TIME]
knob to specify the video transition time.
3. Press a VIDEO INPUT SELECT [1]–[4] button to select the
video.
Button Video status
Lit red Video is being output.
Blinking red Video is transitioning.
The video is switched.