Roland VS-880EX - Page 58

4. Press PARAMETER [ ] [ ] several times
until “EQ Switch=” appears in the display.
5. Rotate the TIME/VALUE dial.
EQ Switch (Equalizer Switch)
If you wish to use the equalizer, set this “On.” If not,
set this “Off.” When equalizer settings are being made,
the equalization curve will be shown graphically in
the bar display. If this is “Off” the equalizer-related
parameters will not be available. For this example,
select “On” so that the equalizer will be applied.
6. Hold down [SHIFT] and press the channel 3 [EQ
Low (CH EDIT)].
7. Use CURSOR [ ] [ ] and the TIME/VALUE
dial to make the setting.
EQL (Equalizer Low)
This adjusts the gain (-12–12 dB) and the center fre-
quency (40 Hz–1.5 kHz) of the low-range (shelving)
equalizer.
8. Hold down [SHIFT] and press the channel 4 [EQ
Mid (SELECT)].
9. Rotate the TIME/VALUE dial.
EQM (Equalizer Mid)
This adjusts the gain (-12–12 dB) of the mid-range
(peaking) equalizer.
10. Press PARAMETER [ ].
11. Use CURSOR [ ] [ ] and the TIME/VALUE
dial to make the setting.
CONDITION MARKER#
MASTER INPUT TRACK AUX
TIME
48
24
4
0
dB
12
Gain Frequency
EQL frequency (40 Hz–1.5 kHz)
Frequency
EQL gain (-12–12 dB)
Gain
0
-
+
If the Display Indicates “Not 3band EQ”
If “Not 3band EQ” is displayed, the EQ Mode
(equalizer mode) is set to “2 band EQ.” In this
case, it will not be possible to adjust the mid-range
equalizer.
CONDITION MARKER#
MASTER INPUT TRACK AUX
TIME
48
24
4
0
dB
12
Gain
EQM gain (-12–12 dB)
EQM frequency (200 Hz–8 kHz)
Gain
0
-
+
Frequency
Chapter 3 Multi-Track Recording
58