Roland XV-3080 - Page 165

165
Parameter List
Appendices
48:3D DELAY(p. 62)
Parameter Value
Delay C Delay time center 0 – 1800 ms
Delay L Delay time left 0 – 1800 ms
Delay R Delay time right 0 – 1800 ms
Fbk Feedback -98 – +98 %
Level C Level center 0 – 127
Level L Level left 0 – 127
Level R Level right 0 – 127
HF Damp HF Damp 200–8000 Hz,
BYPASS(*1)
Out Output mode Speaker, Phones
Lo G Low gain -15 – +15 dB
Hi G High gain -15 – +15 dB
Balance Effect balance D100:0E – D0:100E
Level Output level 0 – 127
1: 200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600, 2000, 2500, 3150,
4000, 5000, 6300, 8000 Hz, BYPASS
49:3VOICE PITCH SHIFTER(p. 63)
Parameter Value
Coarse 1:2:3 Coarse pitch ÇP:2:3 -24 – +12
Fine 1:2:3 Fine pitch 1:2:3 -100 – +100 [cent]
Pre Delay 1:2:3 Pre Delay time 1:2:3 0.0 – 500 [ms]
Fbk 1:2:3 Feedback level1:2:3 -98 – +98 %
Pan 1:2:3 Output pan 1:2:3 L64 – 63R
Level 1:2:3 Level 1:2:3 0 – 127
Balance Effect balance D100:0E – D0:100E
Level Output level 0 – 127
50:LOFI COMPRESS(p. 64)
Parameter Value
Type LOFI type 1 – 9
Pre Filter Pre Filter type 1 – 6
Post Filter 1 Post Filter 1 type 1 – 6
Post Filter 2 Post Filter 2 type OFF, LPF, HPF:(*1)
LowGain Low gain -15 – +15 dB
Hi Gain High gain -15 – +15 dB
Balance Effect balance D100:0E – D0:100E
Pan Output pan L64 – 63R
Level Output level 0 – 127
1: Post Filter cutoff frequency:200, 250, 315, 400, 500, 630, 800, 1000,
1250, 1600, 2000, 2500, 3150, 4000, 5000, 6300, 8000 Hz
51:LOFI NOISE(p. 64)
Parameter Value
Type LOFI type 1 – 9
Post Fltr Post Filter type OFF, LPF, HPF:(*1)
Radio Detune Radio detune 0 – 127:0 – 127 (*2)
Disc:LPF:Lev Disc:LPF:Level *3:*4:*5
LowGain Low gain -15 – +15 dB
Hi Gain High gain -15 – +15 dB
Balance Effect balance D100:0E – D0:100E
Pan Output pan L64 – 63R
Level Output level 0 – 127
*1: Post Filter cutoff frequency:200, 250, 315, 400, 500, 630, 800, 1000,
1250, 1600, 2000, 2500, 3150, 4000, 5000, 6300, 8000 Hz
*2: Radio detune:Radio noise level
*3: Disc noise type:LP, EP, SP, RND
*4: Disc noise LPF:200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600,
2000, 2500, 3150, 4000, 5000, 6300, 8000 Hz, BYPASS
*5: Disc noise level:0 – 127
52:SPEAKER SIMULATOR(p. 65)
Parameter Value
Speaker Type Speaker type (*1)
Mic Set Mic setting 1, 2, 3
Mic:Dir Mic level:Direct level 0 – 127:0 – 127 (*2)
Level Output level 0 – 127
1: Small 1, Small 2, Middle, JC-120, Built In 1, Built In 2, Built In
3, Built In 4, Built In 5, BG Stack 1, BG Stack 2, MS Stack 1, MS Stack 2, Metal
Stack, 2 Stack, 3 Stack
53:OVERDRIVE 2(p. 65)
Parameter Value
Drive Drive 0 – 127
Level Output level 0 – 127
LowGain Low gain -15 – +15 dB
Hi Gain High gain -15 – +15 dB
Amp Type Amp. simulator type OFF,ON:SMALL,
BUILT-IN, 2-STACK,
3-STACK (*1)
Tone Tone 0 – 127
Pan Output pan L64 – 63R
*1: Amp. simulator switch:Amp. simulator type
54:DISTORTION 2(p. 66)
Parameter Value
Drive Drive 0 – 127
Level Output level 0 – 127
LowGain Low gain -15 – +15 dB
Hi Gain High gain -15 – +15 dB
Amp Type Amp. simulator type OFF,ON:SMALL,
BUILT-IN, 2-STACK,
3-STACK (*1)
Tone Tone 0 – 127
Pan Output pan L64 – 63R
*1: Amp. simulator switch:Amp. simulator type
55:STEREO COMPRESSOR(p. 66)
Parameter Value
Sustain Sustain 0 – 127
Attack Attack time 0 – 127
Post Gain Post gain 0, +6, +12, +18
LowGain Low gain -15 – +15
Hi Gain High gain -15 – +15
Level Output level 0 – 127
56:STEREO LIMITER(p. 66)
Parameter Value
Thre Threshold level 0 – 127
Release Release time 0 – 127
Ratio Compression ratio 1.5:1, 2:1, 4:1, 100:1
Gain Post gain 0, +6, +12, +18
LowGain Low gain -15 – +15
Hi Gain High gain -15 – +15
Level Output level 0 – 127