Roland XV-3080 - Page 166

166
Parameter List
57:GATE(p. 67)
Parameter Value
Key Key Source, A, B, C
Thre Key threshold 0 – 127
Monitor Key monitor OFF, ON
Mode Mode GATE, DUCK
Atk Attack time 0 – 127
Hold Hold time 0 – 127
Rel Release time 0 – 127
Balance Effect balance D100:0E – D0:100E
Level Output level 0 – 127
58:SLICER(p. 67)
Parameter Value
Beat 1-1–4-4 Beat 1-1– 4-4 0 –127
Rate Rate 0.05 – 10.0
Attack Attack 0 – 127
Reset Reset OFF, Source, A, B, C
Thre Reset threshold 0 – 127
Mon Reset monitor switch OFF, ON
Mode Mode LEGATO, SLASH
Shuffle Shuffle 0 – 127
Level Output level 0 – 127
59:ISOLATOR(p. 68)
Parameter Value
High Level high -60 – +4 dB
Middle Level middle -60 – +4 dB
Low Level low -60 – +4 dB
Anti Phase Mid (*1) OFF, ON:0 – 127
Anti Phase Low (*2) OFF, ON:0 – 127
Low Boost Low Booster switch/level OFF, ON:0 – 127
Level Output level 0 – 127
1: Anti phase middle switch:level
2: Anti phase low switch:level
60:3D CHORUS(p. 68)
Parameter Value
Pre Dly Pre delay time 0.0 – 100 ms
Rate LFO rate 0.05 – 10.00 Hz
Depth LFO depth 0 – 127
Phase Phase 0 – 180 degree
Filter Type Filter Type OFF, LPF, HPF
Cutoff Cutoff frequency 200–8000 Hz (*1)
Out Output mode Speaker, Phones
Lo G Low gain -15 – +15 dB
Hi G High gain -15 – +15 dB
Balance Effect balance D100:0W – D0:100W
Lev Output level 0 – 127
1: 200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600, 2000, 2500, 3150,
4000, 5000, 6300, 8000 Hz
61:3D FLANGER(p. 69)
Parameter Value
Pre Dly Pre delay time 0.0 – 100 ms
Rate LFO rate 0.05 – 10.00 Hz
Depth LFO depth 0 – 127
Fbk Feedback -98 – +98 %
Phase Phase 0 – 180 degree
Filter Filter Type OFF, LPF, HPF
Cutoff Cutoff frequency 200–8000 Hz (*1)
Step Rate Step rate (*2) OFF, ON:0.1–20.0 Hz
Out Output mode Speaker, Phones
LoG Low gain -15 – +15 dB
Hi G High gain -15 – +15 dB
Balance Effect balance D100:0W – D0:100W
Level Output level 0 – 127
1: 200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600, 2000, 2500, 3150,
4000, 5000, 6300, 8000 Hz
2: Step switch:Step rate
62:TREMOLO(p. 70)
Parameter Value
Mod Wave Modulation wave TRI, SQU, SIN, SAW1,
SAW2
Rate Rate 0.05 – 10.0 Hz
Depth Depth 0 – 127
LowGain Low gain -15 – +15 dB
Hi Gain High gain -15 – +15 dB
Level Output level 0 – 127
63:AUTO PAN(p. 70)
Parameter Value
Mod Wave Modulation wave TRI, SQU, SIN, SAW1,
SAW2
Rate Rate 0.05 – 10.0 Hz
Depth Depth 0 – 127
LowGain Low gain -15 – +15 dB
Hi Gain High gain -15 – +15 dB
Level Output level 0 – 127