occurs
.
◆ 6. Personalized parameter settings
Each setting needs to be done with the bicycle stationary.
The personalized parameter setting procedure is as follows:When the display is ON and the speed shows 0,
(1)
Press and hold simultaneously for more than 2 seconds to enter the personalized parameter settinginterface.
(2)
Press
/
to toggle between the personalized parameter setting interface, and press to enter theparameter changing state.
(3)
Press
/
to select the parameter, long pres for addition operation, long press for subtraction
operation.
(4)
Press to save the parameter settings and return to the personalized parameter setting interface.
(5)
Long Press to save the parameter settings and exit the personalized parameter setting interface.The following options are available on the
personalized parameter setting interface:
6.1
Backlight Brightness Setting
01P is the backlight brightness setting, 00 for darkest, 01 for standard and 03 for brightest.
Short press to enter the parameter changing state. Press the
/
to select the parameter and press to save the parameter setting and return to the personalized parameter setting
interface.
Figure 6-1 Backlight Brightness Setting Interface
To Next Page
Loading...
