..............................................................................
..............................................................................
64
Activating and adjusting the frame
counter for standard magazines
Select menu via switch 44. Then press
memo button 27 to select the item
“Count“. This will be blinking. Press the
shutter release to confi rm. The display
“Count“ and the frame-counter icon “- -“
will stop blinking. “- -“ means that the
frame counter is disabled. Press the memo
button to zero the frame counter.
After selecting the desired frame number,
confi rm by pressing the shutter release.
The next menu item “rESEt“ will appear.
Leave the menu via switch 44. The frame
number chosen will be displayed.
Note:
When changing 6x6 magazines containing
partially exposed fi lm, it will be necessary
to set the counter to the current reading.
Reset
This resets the camera to its defaults. First
select the menu via switch 44. Then press
memo button 27 repeatedly until “rESEt“
is displayed blinking. Press the shutter
release to activate the “rESEt“ menu item.
The display will stop blinking. If you are
sure that you wish to reset the camera to
its defaults, confi rm by pressing the shut-
ter release fully down. Finally, turn switch
44 off its “M“ position.
Should the reset function have been acti-
vated inadvertently but not executed (dis-
play “rESEt“ appears without blinking), it
can be aborted by pressing memo button
27 or resetting switch 44.
FRAME COUNTER
To Next Page
Loading...
Need help?
General
