Rollerdor RD55 - Programming Safety Edge Features; Programming Sequential Operation; Programming Independent Button Operation

7
PROGRAMMING OF REMOTE CONTROL
HANDSETS AND PUSH BUTTON
(SAFETY EDGE)
1
Press and hold the “RADIO PROG” button
(fig.10.1). You will hear 3 beeps and the red LED
alongside “C3” will illuminate.
2
Press top button on handset (fig.10.2A).
The panel will beep to confirm it has accepted.
Repeat for all other handsets.
3
Leave for several seconds and the receiver box
will beep twice to confirm end of programming.
4
Press and hold the “RADIO PROG” button
(fig.10.1). You will hear 4 beeps and the red LED
alongside “C4” will illuminate.
5
Press bottom button on handset (fig.10.2B).
The panel will beep to confirm it has accepted.
Repeat for all other handsets.
6
Leave for several seconds and the receiver box
will beep twice to confirm end of programming.
INDEPENDENT BUTTON
OPERATION
1
Press and hold the “RADIO PROG” button
(fig. 10.1). You will hear a beep and the red LED
alongside “C1” will illuminated. Then release the
“RADIO PROG” button.
2
Press top button on handset (fig.10.2A).
The panel will beep to confirm it has accepted.
Repeat for all other handsets.
3
Leave for several seconds and the receiver box
will beep twice to confirm end of programming.
SEQUENTIAL OPERATION
fig.10.1
fig.10.2
A
B