Need help?Do you have a question about the Rollerdor RD55 and is the answer not in the manual?
Instructions for operating the door using the remote control handset buttons.
Crucial safety advice regarding the need for clear visibility during door operation.
Instructions for operating the door using buttons on the receiver box.
Step-by-step guide to programming remote controls and push buttons.
Instructions on how to replace the battery in the remote control handset.
Operating the door using the left or right triangle and square buttons on the handset.
Using the up, stop, and down buttons on the receiver box to control the door.
Detailed steps for programming remote control handsets using the receiver box board.
Process for removing programmed remote controls from the receiver's memory.
Instructions for replacing batteries in the remote control handset unit.
Using a single button on the remote to open and close the door sequentially.
Using separate buttons on the remote for opening and closing the door.
How to operate the door using the START, STOP, and CLOSE buttons on the receiver box.
Using a wireless keypad to operate the garage door with an access code.
Using a push button with up and down arrows to open and close the door.
Programming sequential operation mode for remote controls and push buttons.
General| Manufacturer | Rollerdor |
|---|---|
| Model | RD55 |
| Motor Type | DC Motor |
| Power | 550W |
| Lifting Capacity | Up to 100kg |
| Voltage | 230V |
| Frequency | 50Hz |
| Warranty | 2 years |
| Safety Features | Obstacle Detection, Auto-Reverse |
| Remote Control | Yes |
To Next Page
