• Allowing debris to remain in the filter will keep the Puro’s filtration from working properly.
• If rinsed, the filter MUST be fully dried before reinstalling. If water enters the inside of the Puro, the vacuum may
sustain serious internal damage.
• To purchase additional filters, please visit our website at www.rollibot.com.
Do not dry in any kind of oven or via heaters or dryers.
5.4 –Cleaning the Filter
Detach the Canister from the Main
Body as seen in Section 5.2. Holding
the top and bottom of the Canister,
twist the top until it opens.
Step 1
Take out the Filter and separate the
mesh from the sponge.
Step 2
Rinse one or both parts of the lter if
desired. After rinsing, allow 24 hours’
time for the lter to dry.
Step 3
Reinstall the lter and top of the
Canister then reattach the Canister to
the Main Body as seen in Section 5.2.
Step 4
High Effiency Filter
09
To Next Page
Loading...
