10
Assemble the Rear Wheels
Helpful Tip:
1. if you encounter trouble fitting both wheels
onto the rear axle, then your rear wheel axle
may need to be realigned,
2. Remove a wheel from the axle. Pull or push
on the axle to slide it until you have enough
room on both sides.
1. Locate the washers and wheel nuts on either side of the rear
axle. Slide the rear wheel onto the axle. Ensure that the gears
on the wheel connect with the gearbox.
2. Slide a washer onto the axle.
3. Slide a wheel nut onto the axle, then use the hex wrench to
tighten.
4. Snap on the wheel cover by aligning the tabs on the cover with
the slots on the wheel.
5. Repeat these steps for the other rear wheel.
To Next Page
Loading...
