13
Assemble the Support Wheels
1. Slide the left support wheel (7) onto the left side of the rear axle.
2. Slide the right support wheel (27) onto the right side of the rear axle.
3. Slide the rear shield (8) onto the left side of the rear axle. Align the slots on the
rear shield with the protrusions on the left fork and snap into place. Ensure the
silver cylinder on the gearbox ts into the bottom hole of the rear shield.
4. Insert a screw (22) into the screwhole on the rear shield and tighten with a
screwdriver.
5. Slide a washer (17) and hexagon nut (19) on both sides of the rear axle. Tighten
both sides with a wrench (18).
17
19
17
19
22
17
19
To Next Page
Loading...
