EasyManua.ls Logo

Rolls Battery - Spillage Procedure

Rolls Battery
23 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
15
SpiLLAgE pRoCEdURE
Small spills may be neutralized using water. Spray the spill from a windward
location wearing protective equipment. Direct the jet to the outside of the
spillage, working your way inward towards the center. Larger spills should be
contained using soda ash, sand or dirt and finally washed down with water
once absorbed.
diSpoSAL pRoCEdURE
Batteries must NEVER be disposed in household waste. To reduce environmental
impacts, bring your battery to a certified recycling depot at the end of its life.
Note: Lead-acid batteries are 97-98% recyclable.
Rolls Batteries have >66% recycled lead.
qUiCk CHECkLiST
SHIPPING
· All parts are included
· No acid spill
· No visual damage to the batteries
INSTALLATION
· Necessary personal protective gear being worn properly
· All electrical components are turned off
· Acid spill cleanup material at hand
INITIAL CHARGE
· Verify electrolyte levels (adjust if needed)
· Measure specific gravity
· Set up battery charge voltage/current limits
GENERAL
· Safety first!