7
Device Overview
1. Mixing container lid
2. Motor unit
3. Kneading spiral and dough screw conveyor with drive shaft
(inside the mixing container)
4. On/Off switch (square) with the switch positions
EXT (“Extruding” )
OFF (“Off” )
MIX (“Mix”=Mixing/kneading)
5. Mode switch (round) with the switch positions
EXT (“Extruding” )
MIX (“Mix”=Mixing/kneading)
6. Mixing container
7. Pasta dies (inside the locking ring)
8. Locking ring
9. Face plate
10. Locking clip of the mixing container lid
------------------ 1
10 ------------------
9 ------------------
8 ----------------
6 -----------------------------
7 ----------
------------------ 2
----------------------------- 3
-------------- 4
-------------- 5
To Next Page
Loading...
