B. Left Side Rail
two (2) "T" Nuts with MACHINE SCREWS
- 12 -
B.LEFT SIDE RAIL.
Step 9: Leg placement
From the top of the side rail measure
down 2-1/2"and from the front measure
in 3-1/8". Drill a 5/8" diameter hole 1/2"
deep.
Step 10: Place the leg pivot into the 5/8" hole.
With the pivot plate parallel to the top & bottom of the side
rail. Drill a 1/4" hole through the bottom 2 (two) holes in the
plate through the side Rails.
two (2) black screws.
Screw through the top 2 holes.
Note: To prevent tear out on the outside of the side rail
clamp a piece of scrap wood to the rail while drilling.
WHEN COMPLETED
REMOVE LEG HARDWARE
Parallel
5/81/2
2- 1/2
3- 1/8
B
To Next Page
Loading...