RoomTec Murphy Bed Building Queen Vertical - Right Side Rail Ball Stud Plate Mounting; Mounting the Lower Ball Stud Plate

- 14 -
Step 11: Mounting the lower ball stud plate to the outside
of the SIDE RAIL PARTS B.
B.RIGHT SIDE RAIL
QUEEN VERTICAL (upright)
PLYWOOD CONSTRUCTION ONLY
Drill 1 diameter PIVOT HOLE OVERHANG
Screw two (2) black
screws through these two (2)
holes
Mark and drill a 1/4" diameter hole
through the SIDE RAIL.
Insert the three (3) T-nuts through
the inside of the SIDE RAIL. Screw
the machine screws through the ball
stud plate into the T-nuts.
7- 1/2
1- 7/8
4
9
1/4
5/16
5/16
END OF SIDE RAIL (PART B)
B