RoomTec Murphy Bed Building Queen Vertical - Attaching Bed Face Panels; Attaching Bed Face Panels to Frame

Lay bed face panel with good side
DOWN, and place assembled bed
frame on top of bed face panel. Check
to make sure the 1/4" lines are visible
on both sides of the assembled bed
frame.
Step 20:
As a guide for the application of the
adhesive, mark a pencil line on the face
panels PARTS E around the inner wood
bed frame. After marking, remove the
assembled wood bed frame and apply
adhesive inside the markings.
Face panel may
extend approx.
1/4" at this end.
Tip:
- 19 -