EasyManuals Logo

RÖSLE VIDERO E2-P User Manual

RÖSLE VIDERO E2-P
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
Product information
14
RÖSLE 2022
Product information
1. Intended use
This electric grill is designed for grilling and reheating
food such as meat, fish or vegetables and is designed
forhousehold and outdoor use only.
Any alternative use is considered contrary to the
intended use and may entail hazards, for example:
f use as a "fireplace" (with charcoal or similar
substances) or heating source
f use indoors, in garages, in covered or enclosed
places such as roofed or covered porches or
terraces,in or on caravans, tents or water craft
f commercial use
f unsupervised use
f use of a rebuilt or modified product. Alterations
andmodifications to the product will invalidate
thewarranty.
2. Components shown
The letters of the components shown refer to the illustra-
tion of the electric grill on the diagram.
Scope of delivery pg. 2.
A – lid with glass insert
B – power cord
C – foot (4x)
D – screws (4x) for foot
E – buckle for closing the lid
F – hook bar for cutlery
G – screws (2x) for hook bar
H – control knob and display
J – Two-piece main grill grate
K – heating coil
L – grease drip tray
M – warming grate
N
1
, N
2
– funnel element in two parts
3. Technical data
Model Videro E2-P/Videro Pro E2-P
Item no: 25582/25589
Power connection: 220–240V/50-60Hz
Maximum wattage 2800W
Device protection class IPX4
Power cord protection class
IP44
Weight
13,9 kg
Dimensions
W 49.7 x H 34.4 x L 46,6 cm
Assembly
Assemble the grill as described on the graphic "Assembly"
on pg. 2.
Before first use
f Wear suitable protective gloves to protect against
scalding.
Prepare the grill for first use as described below and on
the diagrams starting on pg. 3.
1. Remove the main grill grate, warming grate, two-piece
funnel and grease drip tray.
2. Clean the parts with hot water and dry them thor-
oughly.
3. Replace the parts in the following order: Funnel (two-
part, first the rear part), main grill grate, warming
grate.
f Fill the grease drip tray with water up to the max. mark
(approx. 700ml).
f Heat the unit for approx. 15 minutes on the highest
setting.
There may be a slight temporary emission of smoke
due to the combustion of manufacturing residues.
Operation
f Wear suitable protective gloves (grilling gloves) dur-
ing operation and only touch the grill at the points
intended for operation. There is a risk of injury from
hot surfaces.
f Cover a maximum of 80% of the grill surface with
grill food, grill plates, drip trays, pizza stones, etc.,
to avoid accumulated heat in the lower area of the
grill chamber.
f Keep an eye on the water level during operation and
top up water in the grease drip tray promptly as
needed. Never pour water directly onto the heating
elements.
f Before each use, check drains leading to the grease
drip tray for grease accumulation. Remove excessive
grease and deposits to avoid a grease fire.
1. Preparation
1. Slightly pull out the grease drip tray from the side and
fill water into the grease drip tray up to the max. mark
(approx. 700ml).
2. Carefully push the grease drip tray filled with water
back in.
3. Connect the power cord to the power outlet.
f The display lights up briefly after plugging in, a short
signal tone sounds (standby mode)
Refill the evaporated water promptly.
The water in the grease drip tray reduces smoke
development and facilitates subsequent cleaning.
A2_Elektrogrill-VIDERO.indb 14A2_Elektrogrill-VIDERO.indb 14 22.11.2022 16:42:3722.11.2022 16:42:37

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the RÖSLE VIDERO E2-P and is the answer not in the manual?

RÖSLE VIDERO E2-P Specifications

General IconGeneral
BrandRÖSLE
ModelVIDERO E2-P
CategoryGrill
LanguageEnglish

Related product manuals