© 2017 CHARLES ROSS & SON COMPANY
15
E. LUBRICANTS LIST.
Below is a specifications list of the lubricants used in this machine. Please note that specific brand names or
manufacturers are not mentioned. Your local grease/oil distributor will be able to provide a product based on these
specifications. Matching brand names is not important. Also, refer to the Vendor Literature for more specific
information.
1. Reducer - Synthetic AGMA lubricant 7EP or 8EP, ISO-ASTM viscosity grade 460-680.
2. Bearings - Any high temperature, solvent resistant, synthetic bearing grease could be used.
3. Hydraulic Lift System - Any non-foaming, hydraulic oil with an ISO-ASTM viscosity grade 46 (ISO-46,
AW-46) or equivalent.
4. Mechanical Seals - Non-abrasive oil with specific gravity greater than 0.8 with an ISO-ASTM viscosity grade
22 (ISO-22, AW-22) or a similar 10 weight oil.
To Next Page
Loading...