© 2017 CHARLES ROSS & SON COMPANY
3
CAUTION
1. All persons involved in the installation, maintenance or operation of this equipment must completely read
and understand the information contained in this and any associated manual(s) prior to installation,
maintenance or operation.
2. Improper use, operation, installation or maintenance of this equipment may result in personal injury or
damage to the equipment or other property.
3. The equipment must only be used for its intended purpose and in accordance with the procedures outlined
in this manual.
4. All federal, state and local codes apply to the installation, maintenance and operation of this equipment and
shall not be superseded or implied to not apply by instructions outlined in this manual.
5. Other codes or safety standards such as OSHA, ANSI or ISO may apply.
6. Guards, limit switches, safety controls or other safety devices provided with the equipment must be in
place and operational prior to operation of the equipment. All rotating and/or moving parts must be guarded
during operation. Do not override, tie back or manipulate any of the safety features.
7. It is the responsibility of the owner and operator to maintain all safety devices in the properly installed
positions and in proper working order at all times. DO NOT OPERATE THIS EQUIPMENT WITHOUT
ALL SAFETY DEVICES INSTALLED AND OPERATIONAL.
8. Other safety devices not provided with the equipment may be required by national, state, local or company
safety codes. These codes must be adhered to and all devices must be installed properly and operational
prior to use.
9. Regular inspection of all moving parts, electrical wiring and safety devices should be part of regularly
scheduled maintenance and daily operating procedures.
10. All state, local and national electric codes apply.
11. Lockout/disable all power to motors and controls prior to performing any maintenance.
To Next Page
Loading...