3–2 • Installation RCP-QE User Guide (v02)
Installing the Routing Switcher System
The RCP-QE uses a TCP network for connection. It connects to the T-BUS routing devices using either the
NK-NET or the NK-IPS. The NK-NET receives phantom power from the T-BUS devices to which it is connected.
If the device providing power loses power, the NK-NET loses power as well.
The RCP-QE can have up to three more NK-NETs configured as backups in the event that connection is lost to
the primary NK-NET.
Figure 3.1 RCP-QE connected within an NK routing system
To connect the remote control panel in the routing system:
1. Place the RCP-QE into the rack frame and then fix in place with appropriate fasteners.
2. Connect a standard CAT5/5e/6 Ethernet cable to the ETHERNET connector on the rear of the RCP-QE.
3. Connect the other end of the standard CAT5/5e/6 Ethernet cable to the network TCP switch/hub.
4. Connect another standard CAT5/5e/6 Ethernet cable to the network TCP switch/hub.
5. Connect the other end of the standard CAT5/5e/6 Ethernet cable to the ETHERNET connector on the
NK-NET.
6. Connect a standard CAT5/5e/6 Ethernet cable to the T-BUS connector on the NK-NET.
7. Connect the other end of the standard CAT5/5e/6 Ethernet cable to the T-BUS connector on the rear of any NK
device that is connected by T-BUS to an NK Series router (including the router itself).
The NK device(s) must be powered up when the system is connected in order to provide phantom power to the
NK-NET.
8. Connect the 5 V 2 A power supply provided to the POWER connector on the rear of the RCP-QE.
9. Connect the cable from the power supply to a suitable AC mains supply.
The RCP-QE is designed for installation into a standard 19" equipment rack. It has integrated rack ears, allowing
it to be screwed in using standard screws and cage nuts.
TCP Switch/Hub
NK-NET
Routing Switcher
Appropriate
NK Series
power supply
T-BUS
Ethernet
Ethernet
Appropriate
RCP-QE
power supply
RCP-QE
To Next Page
Loading...