RCP-QE User Guide (v02) Setting Up the RCP-QE • 4–5
The Panel Configuration editor opens.
Figure 4.5 The RCP-QE Panel Configuration editor tab in DashBoard
RCP-QE Panel Configuration Editor Field Descriptions
General
Serial Num (read-only) – the serial number is set in the factory before shipping and is unique to each device. This
parameter is not user configurable.
Version (read-only) – the software/firmware version.
Device Details
Name – this field can be assigned by the user to uniquely name an RCP-QE.
This field has a maximum of 16 characters and is used for description and identification only.
Group – a group number can be assigned by the user to organize devices into groups. For example, users can assign
separate group numbers for devices in different physical areas.
This field has a maximum of 10 characters and by default is blank.
Details – assigned by the user to give an RCP-QE specific details. For example, a physical location or a brief
description of its use.
This field has a maximum of 16 characters and is used for description and identification only.
Address – this address is used within the overall control system to identify NK devices using resource management
and protects. Each device must be given a unique T-BUS address to avoid communication conflicts
1
.
The valid value range for assigning an individual device T-BUS address is 1-255.
1. Except when panel-linking is used.
To Next Page
Loading...