Page 2
RXT175P
IMPORTANT
Please read all of the safety and operating instructions carefully before using this product.
Please pay particular attention to all sections of this manual that carry warning symbols and
notices.
WARNING!
This is a Warning symbol. This symbol is used throughout the manual whenever
there is a risk of personal injury. Ensure that these warnings are read and under-
stood at all times.
CAUTION!
This is a Caution symbol. This symbol is used throughout the user guide when-
ever there is a risk of damaging your product. Ensure that these warnings are
read and understood at all times.
GENERAL DESCRIPTION
This welder is a power source for light duty manual arc welding only. It has been designed
and manufactured specifically for continuous MIG welding of carbon or mild steels with and
without protective gas using appropriate cored (tubular) electrode wire or solid wire. Power
for the arc is given by a single phase transformer with a drooping characteristic. It is suitable
for use with 0.6/0.9mm solid or 0.8/0.9mm core wire and for welding materials up to 8mm.
PRODUCT SPECIFICATION
Note: This welder requires a 15 mains supply.
Item RXT175P
Input Power V 230
Frequency Hz 50
Phase No. 1
Rated No-load Voltage V 35 V DC
Rated Input Capacity KVA 5.75 KVA
Rated Duty Cycle % 15
Output current A 30-145A — Peak 175A
Insulation Grade H
Cooling Type Fan Cooled
Case Protection Class IP21S ,not suitable for storage or use in rain
External Dimension:
L x W x H
cm 49cm x 37cm x 24cm
Weight kg 22kg
To Next Page
Loading...
