Programming
30 AC-Q4x Series Installation and Programming Manual
5. Programming
• In the Programming chapter, “code” refers to a PIN code or proximity
card depending on the unit you have.
• When entering a PIN or presenting a proximity card is mentioned, the
meaning may vary between units.
Programming is done solely via the unit’s keypad-driven Programming
Menu System. To reach the Programming Menu System, the
controller must first be placed into Programming Mode (see Section
5.1
).
During the manufacturing process, certain codes and settings are pre-
programmed. These settings are the called default factory settings.
Table 2 shows all the programming menus, with default factory codes
and settings.
Table 2: Programming Menus
Menu
No.
Description Default Section
4
Digits
5
Digits
6
Digits
4-8 Digits
1 Change Open code 2580 25802 258025 25802580
5.3
2 Change Auxiliary code 0852 08520 085208 08520852
5.4
3 Change Program code 1234 12341 123412 12341234
5.5
4 Change Normal/Secure
code
3838 38383 383838 38383838
5.6
5 Change Normal/Bypass
code
NA
5.7
6 Change Door Release time 0004
5.8
Define auxiliary
inputs/outputs
2004
5.9
Enable or disable keypad
heater
3000
5.10
Set Lockout Feature 4000
5.11
Backlight and LED Behavior 5100
5.12
To Next Page
Loading...
Need help?
General
