Controller Operation
36 AYC-Ex5/T65 Series Installation and Programming Manual
4.9 Programming as a Controller
Programming is done solely via the unit's keypad driven
Programming Menu System. To reach the Programming Menu
System, the unit must first be put into Programming mode (see
Section 4.9.1).
During the manufacturing process, certain codes and settings are
pre-programmed. These settings are the called the default factory
settings.
Table 4 shows the names of all the controller programming menus,
as well as all the default factory codes and settings for the units.
Table 4: Controller Programming Menu
Menu
No.
Menu Description Default
4 digits
5
digits
6
digits
4-8 digits
1 Changing Lock Strike Code 2580 25802 258025 25802580
2 Change Auxiliary Code 0852 08520 085208 08520852
3 Changing Program Code 1234 12341 123412 12341234
4 Changing Normal/Secure
Code
3838 38383 383838 38383838
5 Changing Normal/Bypass
Code
N/A
6 Changing Door Release Time 0004
Define auxiliary
inputs/outputs
2004
Set Lockout 4000
Backlight Behavior 5100
7 Enrolling PIN Code N/A
8 Deleting PIN Code N/A
9 Code assignment with
strike/auxiliary
N/A
0 Return to factory defaults or
change PIN code Length
N/A
To Next Page
Loading...
Need help?
General
