Need help?Do you have a question about the Rosslare AYC-Q64B and is the answer not in the manual?
General| Model | AYC-Q64B |
|---|---|
| Category | Controller |
| Manufacturer | Rosslare |
| Power Supply | 12-24 VDC |
| Operating Voltage | 12-24 VDC |
| Tamper | Yes |
| Type | Access Controller |
| Communication | RS485 |
| Operating Humidity | 0% to 95% (non-condensing) |
| Card Compatibility | Mifare |
| Output Formats | Wiegand |
| Input Formats | Wiegand |
| Dimensions | 120 x 80 x 23.2 mm |
Instructions and diagrams for physically mounting the AYC-Qx4 unit.
Illustrates controller wiring with a dual relay secure application appurtenance.
Shows auxiliary output connection using internal power.
Illustrates auxiliary output connection using external power.
Shows wiring diagram for reader application.
Instructions to change the facility code.
Procedure to reset all settings to factory defaults.
Describes the three operational modes: Normal, Bypass, and Secure.
How to change the controller's programming code.
Steps to change the operating mode between Normal, Secure, and Bypass.
Explains how to enroll primary and secondary user codes.
Guide to enrolling user codes using the standard method.
Explains methods for deleting user codes.
Steps to delete user codes using the standard method.
Explains tamper detection mechanisms and their outputs.
Details the lockout feature for preventing access after multiple wrong entries.
Steps to enter the controller's programming mode.
Instructions on how to exit the controller's programming mode.
Steps to change the Normal/Secure access code.
How to set bypass codes and door chime options.
Configure fail-safe/secure, siren, and lock strike release times.
Configuration of the lockout feature for wrong code attempts.
Procedure to set PIN code length and factory defaults.
Steps to replace a lost programming code.
Steps to replace a lost Normal/Secure code.
To Next Page
