Controller Operation
AYC-F/Gx4 Series Installation and Programming Manual 57
4. Perform one of the following:
Enter the 4- to 8-digit PIN code of the
Primary code belonging to the user you
want to delete.
Present the user card of the Primary code belonging to the
user you want to delete.
The left LED flashes green.
5. Enter the assignment digit for the current user slot:
1 activates the Lock Strike relay only default
2 activates the Auxiliary relay only
3 activates the Lock Strike and Auxiliary relays
If the assignment digit is valid, three beeps are heard and the
controller returns to Normal mode.
If the assignment digit is invalid, a long beep sounds and the
controller waits for another assignment digit to be entered.
To Next Page
Loading...
Need help?
General
