HELPFUL HINTS
1. BEFORE STARTING INSTALLATION:
Familiarize yourself with the installation
instructions and lumbar seating system
components (switch, harness, pouch
and bladder)
2. A
IR BAG AND ANTI-THEFT RADIO:
a. If vehicle is equipped with an
A
NTI-THEFT RADIO, the radio code
must be written down prior to
disconnecting battery cable. The
code must be re-entered when the
negative battery cable is re-installed.
b. If vehicle is equipped with an
A
IR BAG, it is advisable to disconnect
negative battery cable for 3 minutes.
3. R
EMOVAL OF NEGATIVE BATTERY CABLE:
Disconnect the negative battery cable
before installing lumbar system
components as a safety precaution.
F
IGURE A
4. A
CCESSORY POWER:
When installing the special terminal into
fuse panel of vehicle. Use as shown in
F
IGURE B.
NOTE: FOR EASE OF INSTALLATION, YOU MAY REMOVE THE SEAT FROM THE VEHICLE. IF
THIS STEP IS PERFORMED, YOU MUST ENSURE THAT ON RE-INSTALLATION, THE
SEAT IS TORQUED ACCORDING TO THE MANUFACTURER
’S SPECIFICATION.
!WARNING!
DO NOT TAP OR SOLDER TO ANY AIRBAG
CIRCUITS(YELLOW TAPE, TUBING, AND
CONNECTORS WILL INDICATE AIRBAG CIRCUITS)
FIGURE B
FIGURE A
PAGE 3
To Next Page
Loading...