ROTAREX FIRETEC B0442 - Product Lifecycle; 10 Disposal and Recycling; 11 Malfunctioning; 12 Guarantee and Warranty

Instruction manual
Manual release device B0442
CEODEUX Extinguisher Valves Technology S.A.
Page 8 of 8
027650063
9 Product lifecycle
The product has a maximum life of 15 years when used according to its “Intended use” (refer to chapter 2), if the product
is used under normal operating conditions.
(1) Normal operating conditions exist if all requirements listed here are met:
• The product is only used in environments with a relative humidity of 20 % - 80 %
• The product is only used within the prescribed temperature range according to chapter 5.1.
• The product is only used in non-corrosive environments and non-aggressive atmospheres
• The product is not exposed to any vibrational load and vibration stresses
• The general maintenance instructions according to chapter 8.1 are strictly observed
(2) If one or more of the requirements in paragraph (1) are not met, there are no normal conditions of use and
adjusted inspection and maintenance intervals have to be dened with CEODEUX Extinguisher Valves
Technology S.A.
CEODEUX Extinguisher Valves Technology S.A. recommends to replace the product after 10 years.
10 Disposal and recycling
The customer is responsible for the proper and environmentally compatible disposal of all waste arising in connection with
the product.
At the end of its life, the product must be properly disposed of according to national recycling regulations.
11 Malfunctioning
Malfunctions of the manual release device can be caused by contaminations and foreign bodies in the release device
connection (A) of the electromagnetic release device and/or in the connection (C) of the manual release device.
Make sure that the release device connection (A) of the electromagnetic release device and the connection (C) of the
manual release device are clean before installing a manual release device on the electromagnetic release device.
Further possible malfunctions:
Type of malfunction Possible cause Remedy
The manual release device does
not activate
The connection is soiled or damaged. Clean the connection using compressed
air. If the malfunction persists, contact
your distribution partner.
The safety pin
2
can not be
removed
The connection is soiled or damaged. Clean the connection of the safety pin.
If the safety pin is still stuck, replace the
manual release device.
12 Guarantee and warranty
For guarantee and warranty refer to our general terms and conditions.
This instruction manual is an integral part of the sales contract and is subject to our general terms and conditions.
13 Revision history PG.G.04.004
Index Modication
number
Modication Date Checked /
approved by
- - Initial version.
This instruction manual 027650063 replaces all previous
instruction manuals. All manual release devices have been
summarized in this instruction manual 027650063.
2020/01/20 M. Mittasch