To Next PageTo Next Page
Need help?Do you have a question about the Rotel RA-06 and is the answer not in the manual?
General| Signal-to-Noise Ratio (Phono) | 80 dB |
|---|---|
| Input Sensitivity (Line) | 150 mV |
| Input Sensitivity (Phono) | 2.5 mV |
| Input Impedance (Phono) | 47kΩ |
| Damping Factor | 180 |
| Frequency Response | 10Hz - 100kHz |
| Total Harmonic Distortion | <0.03% |
| Signal to Noise Ratio | 100dB |
| Input Impedance (Line) | 24kΩ |
Information and operation guide for the RR-AT94 remote control unit.
Information on connecting the amplifier to the AC power outlet.
How to operate the power switch and understand the power indicator light.
Connecting a turntable to the phono input and ground terminal.
Connecting components like CD players, tuners, and recorders to line inputs.
Connecting tape recorders to the tape input and output jacks.
Using the switch to select speaker sets A, B, or both.
Notes on speaker impedance requirements for optimal performance.
Guidance on choosing appropriate speaker wire for sound quality.
Adjusting the listening volume using front panel or remote.
Adjusting the left-to-right sound balance.
Activating or bypassing the tone control circuits.
Adjusting bass and treble frequencies when tone controls are active.
Selecting the input signal source for listening and recording.
Selecting audio signal for listening from source or tape.
Temporarily muting the system's sound output.
Connecting external infrared receivers for cabinet installations.
Relaying IR signals to other Rotel components.
Steps to diagnose why the power indicator light is not on.
Troubleshooting steps for when there is no audio output.
