Rotel RMB-1075 Technical Manual

Table of Contents
Specification
Specification..................................... 1
Parts List .......................................... 2,3
Adjustment....................................... 4
Note On Safety................................. 4
Case Outlines................................... 5
PCB Assembly ................................. 5,6,7,8
Schematic Diagram.......................... 9,10,11,12
Continuous Power Output (20-20 kHz < 0.03%, 8 ohms) 100 Watts/ch
Total Harmonic Distortion (20-20 kHz, 8 ohms) < 0.03%
Intermodulation Distortion (60 Hz: 7 kHz, 4:1) < 0.03%
Frequency Response (± 0.5dB) 10Hz-80kHz
Damping Factor (20-20K Hz, 8 ohms) 180
Speaker Impedance 4 ohms minimum
Signal to Noise Ratio, (IHF A network) 115 dB
Input Impedance/Sensitivity 27 k Ohoms/1.0 volt
Power Requirement 115 volts 60 Hz or
230 volts 50 Hz
Power Consumption 800 watts
Dimensions (W x H x D) 440 x 139 x 396mm
173/8" x 51/2" x 155/8"
Weight (net) 15.5 kg, 34.1 Lb.
SHINSEN-BLD. 4F 10-10 SHINSEN-CHO, SHIBUYA-KU,
TOKYO 150-0045, JAPAN
Serial. NO.
Begining
®
Quality Uncompromised
Y-336A-00125C/S-S
RMB-1075

Rotel RMB-1075 Specifications

General

Number of Channels	5
Input Sensitivity	1.5 V
Power Output	120 watts per channel (8 ohms, all channels driven)
Frequency Response	10Hz - 100kHz
Total Harmonic Distortion	< 0.03%
Signal to Noise Ratio	116 dB