Need help?Do you have a question about the Rotel RSP-1066 and is the answer not in the manual?
Controls the main power and standby mode of the unit.
Adjusts the audio output level for all channels.
Selects audio or video source components for listening.
Explains analog matrix encoding and Dolby Pro Logic II decoding.
Details the digital 5.1 channel format used for DVDs and digital TV.
Describes the competing digital DTS 5.1 format and its usage.
Connects digital audio sources like DVD players and CD players.
Sends digital audio signals to recorders or processors.
Routes video signals to the television monitor.
Sends audio signals to amplifiers or powered speakers.
Manages Zone 2 with repeaters, output levels, and remote control.
Manages independent power states for Zone 2 and the main room.
Uses front-panel ZONE button for Zone 2 adjustments.
Selects current input for listening, including analog and digital.
Maps sources to specific analog/digital jacks and sets auto-sensing.
Defines default surround mode for each input source.
Optimizes Pro Logic II for Music, Cinema, or Emulation modes.
Optimizes Neo:6 for Music or Cinema surround decoding.
Configures speaker size (Large/Small) and bass redirection for optimal sound.
Sets up single or dual center back speakers for surround modes.
Configures subwoofer presence and bass redirection.
Uses an SPL meter and test tones for precise speaker level setup.
Resets all settings to original factory configuration.
Stores current custom configuration as a user default.
General| Type | Surround Sound Processor |
|---|---|
| Audio Channels | 7.1 |
| Audio Formats Supported | Dolby Digital, DTS, Dolby Pro Logic II |
| Signal-to-Noise Ratio | > 100 dB |
| Input Impedance | 47 kΩ |
| Input Sensitivity | 200 mV |
| Output Impedance | 100 Ω |
| Inputs | Optical, Coaxial, RCA |
| Outputs | RCA |
| Frequency Response | 20 Hz - 20 kHz |
To Next Page
