ROTORCOMP EVO2 - Oil Drain Point; Filling with Oil

Operating Manual - EVO
®
Line
[en] 07/2020 7.3
7.3.2 Oil drain point
The system should be at operating temperature in
this case.
Note:
Dispose of the used oil according to the applicable
regulations
•
Switch off the screw compressor air end with
the main switch and selector switch and secure
against being switched on again.
•
Completely release the pressure in the screw
compressor air end system.
•
Slowly unscrew the screw plug on the oil filler
opening.
•
Carefully unscrew the oil drain screw and catch
the used oil in a suitable container.
•
Clean the oil drain screw and screw in again.
7.3.3 Filling with oil
Caution:
Observe the oil recommendation, see "Lubricants
and Operating Materials". Add oil of the same oil
type and the same brand.
A conversion to another oil type may require flush-
ing of the compressor module.
ROTORCOMP recommends also replacing the oil
filter during an oil change.
•
Replace the oil filter if necessary.
•
Pour oil into the filler neck on the separator tank
up to the maximum level and screw the screw
plug onto the filler neck by hand.
•
Switch on the screw compressor and allow it to
run for approx. three minutes.
•
Oil level check:
Top up the missing oil quantity again up to the
maximum level.
•
Check sheet entry (see chapter 7.4 "Mainte-
nance check sheet").