ROTOTILT ICS Direct - Handle Controls; Handle Operation

© Rototilt Group AB 2018-04-27
S3
R3
T5
Left Handle
Right Handle
EN
English
!
IMPORTANT - The base machine/excavator’s factory
mounted handles have been replaced with handles
adapted for ICS Direct.
Carefully check the changed functions, for both the base
machine/excavator and alternative control.
Display
The symbol on the display comes on
when alternative operation is activated.
Handles
The handles are equipped with switches
and rollers to control the functions on
the base machine/excavator and for
alternative control.
The rollers in the handles must have
proportional control.
The handle functions are congured by
an authorised installer.
One of several possible examples of
connection to the alternative control is
described below.
Left Handle
S3 Activate alternative control
R3 Steering
Right = Turn right
Left = Turn left
Right Handle
T5 Drive
Up = Drive forward
Middle = Neutral
Down = Drive backwards
Information about functions
Information concerning the handles'
current conguration is available in three
places: On the decal, on the display and
in the instructions for the base machine/
excavator.
2200401_ _7225