© Rototilt Group AB 2018-04-27
Inactivate
3
Activate
Sound
2
Shut off
Lever
Light
20
1
EN
English
Malfunctioning
When an error code is generated from a
function, all functions are blocked.
Once the error code has been identied
in the trouble shooting table, the buzzer
can be temporarily switched off.
The buzzer stops if the activation switch
is pressed and held for 3 seconds.
Restarting activates the buzzer again.
Alternative connection
ICS Direct Wheel control can also be
connected to a frequency sensor in the
base machine/excavator’s transmission.
Once contact has been established
between the control system and the
frequency sensor, the system can be
activated.
Activate alternative control
1. Deactivate the operation inhibitor and
drive at a low speed, max 20 km/h.
2. Activate alternative control with the
connected switch in the handle.
Deactivate
3. ICD Direct is deactivate with the
connected switch in the handle.
4. Use the base machine/excavator’s
control for steering (wheel).
Alternative steering always has a
lower priority than the base machine/
excavator’s control. The control
system's indicator lamp ashes and
the buzzer sounds for 3 seconds to
warn that the system is switched off.
Safety latch
The speed must not exceed the permitted
limit, that is why alternative steering is
shut-off when the speed limit is exceeded.
The control system's indicator lamp ashes
and the buzzer sounds for 3 seconds to
warn that the system is switched off.
If the speed is lowered immediately the
system continues to be active.
Connection to the frequency sensor is
used on base machines/excavators not
tted with a drive mode switch.
i
INFO - If the voltage to the base machine/excavator
fails, the base machine/excavator must rst be driven at a
low speed so that the system can be reactivated.
!
IMPORTANT - The speed must not exceed the
permitted limit, that is why alternative steering is
shut-off when the speed limit is exceeded.
To Next Page
Loading...
