RMS-LOG Wireless / LAN Data Loggers
E-M-RMS-MLOG-868-V1_0.docx
Instruction Manual
3 Installation
The following instructions describe installation of the data logger step by step.
1
Insert the battery.
Make sure it is inserted
correctly. The poles are
marked on the battery and
on the electronics.
2 Put on the housing cover.
3
The wall bracket is fastened
to the wall with screws. The
screws may only protrude
so far that the device can
click into place properly
when put on to the fastened
cover.
© 2016 ROTRONIC AG Bassersdorf Switzerland Page 10 of 22
To Next Page
Loading...