How to fix Rovatti Pompe S2K80/3 Water Pump overheating?
If your Rovatti Pompe Water Pump is overheating, there are a couple of things you can check. First, the gland packing might be too tight, so try loosening it. Second, there might be insufficient capacity, so open the discharge valve to increase the capacity.
What to do if Rovatti Pompe Water Pump has air pockets?
If your Rovatti Pompe Water Pump or pipeline is inadequately filled or has air pockets, you should eliminate the air from the pump and pipeline.
What to do if Rovatti Pompe Water Pump bearing or wear ring is damaged?
If you have a damaged bearing or wear ring, stop the pumping unit.
Why is my Rovatti Pompe S2K80/3 making noise and vibrating?
Noise and vibrations in your Rovatti Pompe Water Pump can stem from several causes. It might be due to the pump or pipeline not being adequately filled or having air pockets—in this case, eliminate air from the pump and pipeline. Alternatively, there could be an excessive suction head, excessive wearing of hydraulic components, or the pump and motor could be misaligned or wrongly coupled; for these issues, it's best to contact the installer of the pumping unit or Assistance Service. Pipe resonance can also cause vibrations, so contact the installer of the pumping unit. Check the oil quantity and integrate if necessary, if missing bearings lubrication is the cause. Finally, unbalanced rotor or defective or worn bearings can cause noise and vibrations, so contact Assistance Service, in the l...
Explains the identification plate and its importance.
Explains symbols used for safety and electrical/mechanical equipment.
Stresses operations by skilled personnel following safety rules.
Advises on necessary protective devices and area safety.
Details dangers from moving parts, edges, electricity, and heat.
Details checks after receiving the product and before installation.
Explains horizontal installation, alignment, and base requirements.
Stresses that starting must be done by qualified personnel.
Provides step-by-step instructions for starting the pump.
Lists common faults, causes, and remedies for pump issues.
General| Category | Water Pump |
|---|---|
| Model | S2K80/3 |
| Frequency | 50 Hz |
| Max Liquid Temperature | 90 °C |
| Type | Centrifugal Pump |
| Voltage | 400 V |
| Inlet/Outlet Diameter | 80 mm |
To Next Page