How to fix Rovatti Pompe Water Pump overheating?
If your Rovatti Pompe Water Pump is overheating, there are a couple of things you can check. First, the gland packing might be too tight, so try loosening it. Second, there might be insufficient capacity, so open the discharge valve to increase the capacity.
What to do if Rovatti Pompe S2P85 has air pockets?
If your Rovatti Pompe Water Pump or pipeline is inadequately filled or has air pockets, you should eliminate the air from the pump and pipeline.
What to do if Rovatti Pompe S2P85 Water Pump bearing or wear ring is damaged?
If you have a damaged bearing or wear ring, stop the pumping unit.
Why is my Rovatti Pompe S2P85 Water Pump making noise and vibrating?
Noise and vibrations in your Rovatti Pompe Water Pump can stem from several causes. It might be due to the pump or pipeline not being adequately filled or having air pockets—in this case, eliminate air from the pump and pipeline. Alternatively, there could be an excessive suction head, excessive wearing of hydraulic components, or the pump and motor could be misaligned or wrongly coupled; for these issues, it's best to contact the installer of the pumping unit or Assistance Service. Pipe resonance can also cause vibrations, so contact the installer of the pumping unit. Check the oil quantity and integrate if necessary, if missing bearings lubrication is the cause. Finally, unbalanced rotor or defective or worn bearings can cause noise and vibrations, so contact Assistance Service, in the l...
Information on pump series covered by the manual, including S, SQ, SP, and SK.
Explanation of the identification plate and its importance for warranty and data.
Details risks related to mechanical components, edges, electric hazards, and thermal hazards.
Specifies the operating limits and conditions for the pumps, including temperature and pressure.
Explains the coding system used to identify different pump models and series.
Details on correct pump installation, alignment, and site requirements for motors.
Step-by-step guide for correctly starting the pump and adjusting delivery flow.
Product data complying with ecodesign regulations, including efficiency index and variable duty points.
CE conformity statement for specific pump series, confirming compliance with directives.
CE conformity statement for other pump models, including ErP Directive compliance.
General| Category | Water Pump |
|---|---|
| Model | S2P85 |
| Type | Centrifugal Pump |
| Max Flow Rate | 85 m³/h |
| Inlet Diameter | 80 mm |
| Speed | 2900 rpm |
To Next Page