To Next PageTo Next PageHow to fix Rovatti Pompe Water Pump overheating?
If your Rovatti Pompe Water Pump is overheating, there are a couple of things you can check. First, the gland packing might be too tight, so try loosening it. Second, there might be insufficient capacity, so open the discharge valve to increase the capacity.
What to do if Rovatti Pompe S2P65 has air pockets?
If your Rovatti Pompe Water Pump or pipeline is inadequately filled or has air pockets, you should eliminate the air from the pump and pipeline.
What to do if Rovatti Pompe Water Pump bearing or wear ring is damaged?
If you have a damaged bearing or wear ring, stop the pumping unit.
Why is my Rovatti Pompe S2P65 Water Pump making noise and vibrating?
Noise and vibrations in your Rovatti Pompe Water Pump can stem from several causes. It might be due to the pump or pipeline not being adequately filled or having air pockets—in this case, eliminate air from the pump and pipeline. Alternatively, there could be an excessive suction head, excessive wearing of hydraulic components, or the pump and motor could be misaligned or wrongly coupled; for these issues, it's best to contact the installer of the pumping unit or Assistance Service. Pipe resonance can also cause vibrations, so contact the installer of the pumping unit. Check the oil quantity and integrate if necessary, if missing bearings lubrication is the cause. Finally, unbalanced rotor or defective or worn bearings can cause noise and vibrations, so contact Assistance Service, in the l...
Details about the pump manufacturer and contact information.
General description of pump series covered by the manual.
Required operator skills, protective equipment, and safety guidelines.
Guidelines for pump installation and necessary pre-installation inspections.
Step-by-step guide for safe pump operation initiation.
Diagnosing and resolving frequent issues with the pumps.
General| Model | S2P65 |
|---|---|
| Category | Water Pump |
| Inlet diameter | 65 mm |
| Outlet diameter | 65 mm |
| Max Flow Rate | 60 m³/h |
| Speed | 2900 rpm |
| Voltage | 400 V |
| Frequency | 50 Hz |
