Rover Scottbonnar - Setting Up; Engine Oil; Engine Fuel; Adjusting the Cut Height

SETTING UP
Plastic grass catcher assembly
 Refer to the “Set Up Instructions” attached to the grass catcher lower half.
Figure 1. Grass Catcher—Assembled
Engine oil
Oil must be added before attempting to start the engine otherwise damage to
the engine will occur.
Refer to the engine owner’s manual.
The 4 stroke engine fitted to the lawnmower is shipped with no oil in the sump.
Engine fuel
Refer to the engine owner’s manual.
Use only fresh unleaded fuel in the lawnmower engine.
OPERATION - All mowers
Adjusting the cut height– refer figure 2.
The lawnmower 13 height settings are controlled by the
height adjustment lever located at the rear right hand
wheel.
 Grasp the height adjustment lever (1) and pull the lever
away from the base to disengage the lever from the
height adjustment rack (2).
 Move the lever either forwards or backwards to the
desired position and release the lever so as to engage
in the height adjustment rack.
Figure 2. Height
adjustment
3