ROVI X3 - Transferring Onto or Off the Power Wheelchair; Ramps and Slopes

II
26
· WARNING Do not carry passengers on your power wheelchair. Carrying
passengers may affect the center of gravity, resulting in a tip over
or fall.
Transferring Onto or Off the Power Wheelchair
· WARNING Always fasten the lap belt when operating your power wheel-
chair; the lap belt is there for safety and protection.
Before you transfer onto or off the power wheelchair, engage the drive/freewheel levers in drive
mode and power the joystick controller off. It can be dangerous if you bump into the joystick when
the power is on. When you are sitting or traveling in your wheelchair, always maintain your center
ofgravity.Useapositioningbeltifthereisoneavailable.Formaximumsafety,practiceyourtrans-
fer onto and off of the wheelchair. All practice moves should be under the supervision of a trained
assistant. Do not stand on the footplate. Ensure armrests and footplates have been moved out of the
way before transferring onto or off the wheelchair.
Ramps and Slopes
· WARNING Always reduce your speed when driving down slopes to maintain
stability and avoid hard braking. Move the joystick slowly toward
the center position to reduce speed. If stopping is necessary,
release the joystick and allow the power wheelchair to come to a
full stop.
Ramps are designed for negotiating steps or other obstacles with a manual or power wheelchair. In-
spect the ramp periodically for wear and loose or damaged parts and repair or replace if necessary.
Properly designed ramps will have “edge protection” along each side to prevent the wheelchair
from falling off the ramp. Make sure the ramp is secured in place and does NOT exceed any grade
greater than 8º (14%). Approach a ramp or slope straight on – not at an angle.