III
35
Battery Charging Instructions
1. Verify the charger is the 24Vdc 8A charger supplied with the ROVI
®
X3
2. Plug the charger into the electrical outlet; LEDs indicate when the charger is powered on.
3. Connect the charger to the charging port at the front of the VR2/R-Net joystick controller.
4. Observe the LEDs on the front of the charger for the following indications.
Charger Indicator Lights
1. Blinking Green: Power on; charger in stand-by mode
2. Steady Orange: Battery charging
3. Steady Green: Charging complete
Please refer to the LED indicator descriptions for the charging status on the charger.
Batteries that go below a minimum voltage, as a result of not being charged, will not be able to re-
charge.
Battery/Charging Troubleshooting
Charger Diagnostics
If the charger indicator light goes to green within a few minutes after being plugged in and does not
charge the batteries, then the batteries may be overdischarged and may require additional service
or replacement. Contact your service provider for assistance.
If the charger indicator light goes immediately to green when plugged in to charge, the problem
is likely a blown fuse, popped circuit breaker (push reset button), or similar malfunction. Contact
your provider for assistance. If the charger does not come on at all when plugged in, check the
charger fuse if applicable, then call your provider.
To Next Page
Loading...