6
steam and, at high temperatures, can form deposits in the steam chamber, which
will mark the laundry when they are emitted through the steam vents. For this
reason descaling liquids should not be used.
SERVICE/SPARE PARTS
Rowenta (U. K.) Limited has a network of Service Agents throughout the country
(see enclosed Service Information leaflet). These Service Agents carry out in-
guarantee repairs (free of charge) and out-of-guarantee repairs (chargeable) on
behalf of Rowenta. Should service be required, or the appliance appear faulty,
consult your local Rowenta Service Agent in the first instance. If a product
develops a fault during the guarantee period, it is the responsibility of the
consumer to supply to the Service Agent proof of the date of purchase of the
appliance (e. g. completed guarantee card and/or receipt showing the date of
purchase).
In cases of difficulty contact the Rowenta Consumer Relations Department (see
enclosed Service Information leaflet).
GUARANTEE (U. K. only)
Details of the Rowenta guarantee are shown on the guarantee card enclosed with
the appliance. This guarantee does not affect your statutory rights.
Should service or further information be required please contact the Rowenta
Consumer Relations Department (see enclosed Service Information leaflet).
In line with a policy of continuous product improvement Rowenta
reserves the
right to change product specifications without prior notice
.
TROUBLE SHOOTING
Problem Possible cause Solution
Iron is DISTILLED WATER DO NOT use 100% pure distilled water,
leaking. use tap water. In very hard water areas
mix half tap water with half distilled to
reduce hardness; or use inexpensive
bottled spring water.
SOFTENED WATER Most softened water is alright, but if you
experience leaks or spitting, change to
untreated tap water or inexpensive
bottled spring water. DO NOT use
100% distilled water.
Auto-off activated? Move iron or gently shake.
(depending on model)
Overuse of burst of Allow more time between each burst.
steam.
Iron won't Is iron plugged in? Check plug is in socket.
heat. Thermostat set too Turn thermostat higher.
low?
Auto-off activated? Move iron or gently shake.
(depending on model)
Ready light This is normal. The light goes on and off showing the
goes on thermostat is switching the heat on and
and off. off to maintain the correct temperature.
Iron does Iron is not hot If the iron is not hot enough the anti-drip
not steam. enough. system will activate and stop the iron's
steam production. Set thermostat to
higher position. Always allow iron suf-
ficient time to heat up (indicator light
goes out) before activating the variable
steam control.
Is variable steam If iron is fitted with a variable steam
control correctly set? control, turn it to a higher setting.
Steam valve is Move variable steam control from min to
clogged. max several times to clear blockage.
To Next Page
Loading...
Need help?
General
