ㅤ EN ㅤ
19
REPLACING THE STYLUS
Take off the stylus
To remove the stylus, hold the tone arm and the plastic stylus holder and gently pull the
white stylus holder towards you, away from the cartridge. Repeat the procedure in reverse
to insert the pin.
TROUBLESHOOTING
Make sure that the unit’s power cord is connected to an
appropriate electrical outlet and the wall socket is switched on.
Rotate the volume knob clockwise to increase the volume.
The vinyl record will not
play
Make sure the phono function is selected.
Make sure you have selected the right speed (33, 45RPM).
Nothing will play via the
USB device
Make sure the memory device is properly inserted in the USB
port and the correct function is selected.
NOTE: If normal operation cannot be obtained, unplug the power cord from the power outlet
wait 10 seconds and plug it in again.
To Next Page