12
Maintenance
• Clean the machine with a soft wet cloth.
• Pull the louver on the front panel out to access the filter.
• Remove the filter mesh out of the unit.
• Use a clean rag to adsorb the surface dust on the filter mesh. If the filter is extremely dirty,
use tap water to flush and clean the filter. Fully dry the filter before putting it back
into position. A clean filter will increase the machine’s capacity.
MACHINE STORAGE
If you don’t use the unit for an extended period of time, please store it per the following steps:
(1) Clean the filter mesh.
IMPORTANT: The evaporator inside the machine must to dry before the unit is packed as this will avoid component damage and possible mold.
Unplug the unit and place it in a dry open area for days to ensure it is completely dry. A second alternative to dry the unit is to set the humidity point
more than 2% higher than the ambient humidity of the room. This will enable the fan inside the unit to dry the evaporator after a few hours of usage.
(2) Neatly wind the power cord and place it at the back of unit.
(3) Store the unit in a clean, dry environment.
To Next Page
Loading...
