RDHC-110
9
Drainage
The commercial dehumidifier provides you two options: Dehumidifying using water pump and continuous drainage options.
Dehumidification (using built in water tank)
1) When the tank is full, the “FULL” light will turn on and the unit will make a buzzing sound. Press the power button.
2) Open the front panel to access the water tank to empty the water tank.
3) Grab the handle of the water tank and pull it out horizontally.
4) Dispose of the water. Replace the tank, close the front panel.
Continuous drainage
Note:
In extremely wet conditions, the tank may need frequent clearing.
1. Open the front cover, remove the water tank, and dispose of any water from the tank.
2. Remove the plug and install the included drain pipe to the connector (refer to picture below).
Next, direct the pipe/hose to the desired area before operating the machine
3. Clean the water tank, drain the hose and pipe connector. Close the front panel.
NOTE: To return to water tank usage, use the sealing washer, without the hole to stop water flowing out of the opening
WARNING: Do not block the drainage hose. The end of the drainage pipe should not be higher than the outlet hole. If the drainage pipe end is higher than the outlet hole, water
will not drain properly and could possibly damage components of the unit.
Drain Hose
To Next Page
Loading...
