Royce 610 - Page 32

To Next Page

To Previous Page

4-3

4.2.2.1 Semi Auto Setup Procedure

Install the sample in the sample holder.

Position the sample holder on the base plate.

Adjust the sample holder position so that the pull hook is on the right side of wire to be

tested.

Position the hook foot parallel to the sample wire with the foot pointing toward the

operator.

Enter the “TEST SETUP” menu

Choose the “LOWER HEIGHT” item

Move the hook down until the foot is sufficiently below wire level to allow the hook to

rotate 90° and not collide with the wire.

Press the center mouse button to set lower height.

Select “SEMI AUTO” in the “TEST SETUP” menu.

4.2.3 Failure Codes

The System 610 provides the ability to assign failure codes to each test. Codes 1 thru 9

can be assigned by the operator after inspection of the failure. Codes 10 thru 13 are

automatically assigned by the system.

Failure codes are assigned to a test with the optional keypad or the mouse. To assign a

fail code with the keypad, press the numeric key that corresponds to the failure. The

keypad is also required to edit the text that is assigned to fail codes 1 thru 9 or to void a

completed test. The mouse can be used to enter 5 failure codes (1 thru 5). The left

button selects code 1, the center button selects code 2, the right button selects code 3,

moving the mouse to the left selects code 4, and moving the mouse to the right selects

code 5.

List of Failure Codes and Text

CODE 1: NECK BREAK

CODE 2: SPAN BREAK

CODE 3: DIE INT BRK

CODE 4: SUB INT BRK

CODE 5: DIE MT LIFT

CODE 6: SUB MT LIFT

CODE 7: DIE FRACT

CODE 8: SUB FRACT

CODE 9: FAIL TEXT 9

CODE 10: OPERATOR VOID

CODE 11: TEST CANCELLED

CODE 12: OVERTRAVEL

CODE 13: NO CODE ASSIGNED