20
ENGINE OIL
Recommended Oil
Use the recommended oil, the oil does not need additives.
Do not use graphite oil or oil with molybdenum additives.
Do not use castor based racing oil, vegetable oil or non-detergent oil.
Checking and Adding Oil
1. Park your motorcycle on level ground and use the side stand for support.
2. Start the engine and let it run for 3-5 minutes.
3. Turn the engine off and wait for at least 10 minutes.
4. Remove the oil fill plug/dipstick and wipe clean.
5. Hold the motorcycle in an upright position.
6. Insert the dipstick in the oil fill until it rests on the metal, do not screw it in.
7. Remove the dipstick and check the oil level.
If the oil is at or near the upper level mark there is no need to add oil.
If the oil is at or near the lower level mark, add the recommended oil until it
reaches the upper level mark and do not overfill.
To Next Page
Loading...
Need help?
General
