22
m)
Pass the end of the spinnaker halyard around the sheave and through the cleat as
shown, and tie knot #3 in the tail.
Remember to secure the other end of the spinnaker halyard near the base of the mast.
4.6.5 - Dressing the Mast - Halyards
o)
n)
Remember to secure both ends at the bottom
of the mast once the halyard is tted.
Add a plastic bobble to the other end of the spinnaker
halyard (the end emerging from top of the mast).
If you are using the club spinnaker or
symmetric spinnaker, lead the other end of
the halyard back down from the head of the
mast and pass it through the metal casting
on the front face of the mast (approximately
75mm from the mast head).
If you are using the race spinnaker move
straight on to the next step.
To Next Page
Loading...
