31
g)
f)
4.8 - Rough Rig Setting
Once you have reached the base settings, add
the velcro shroud straps between the shroud and
lower bottle screws to prevent them from working
loose.
Using a rig tension gauge, wind down the cap
shrouds and lowers in equilibrium until they reach
the numbers shown on this table.
50
400
200
100
kg
50
50
50
25
25
25
25
75
50
Tape all split pins / rings.
Base is set at 7-11knots. Headstay is 120 on gauge with backstay slack | *Full turns on the adjusters. Tensions using the Spinlock Rig Sense Gauge.
Wind Speed
(Knots)
Cap Shroud
(full turn)*
Tension
Lowers
(full turn)*
Tension Jib Car Tack Height Vang/Kicker
0-6 -2 200 -1 120 1 2.5” snug to max ease
7-11 275 155 1 2” snug to max ease
12-15 +4 400 0 155 2 1” snug +
16-20 +6 475 +1 212.5 3 1” tight
To Next Page
Loading...
