49
4.24 - Adding the Epropulsion Motor
c)
b) Throttle installation
Make sure the proposed location
reserves enough room for operating
and will allow rotating the throttle
without hitting obstructions. This will be
approximately 85mm above the deck.
Drill holes in the console through the
xing guide referring to the dimensions
in the drawing.
Fix the throttle to the side of the
console using the 4 No.6 x 16
self tapping screws provided.
3 x
20mm
60mm
32.5mm
Now connect 3 cables to the back of the
throttle. First the thinner cable coming from
the motor, then the kill switch cable and
nally the communication cable that will go
to the display panel.
Note: Make sure the correct cable is
connected to the correct port on the back
of the throttle, as indicated below.
Display
Panel
Motor Port
(Connect to
Communications
Module)
Kill
Swich
To Next Page
Loading...
